starting a workout on a route not on startpoint

Bugreport for Sports Tracker

15-04-2009 14:01

Hi,

yesterday I had a workout and stopped it after some time because I wanted to see the route I recorded some days before. So I started a new workout and configured the pre-recorded route with it. But not on route startpoint. So at the end NST added the route from startpoint of the route until the point I started the recording.
Also If I configure this workout with "no route" it still has the data.
On my mobile I have a speed of appr. 2000 km/h, on the website the diagramms for speed looks ok.
I am not sure if real distance in workout is correct. I think not.
I am not sure if this is it what it should do.
I also can send a link to NST-Website with this workout.

My mobile: E66 (102.07.81) & NST 2.06

Comments

Submitted by djh.sthlm on 16-04-2009 01:55.

@mirmer, Yes, if you don't mind sharing your workout, a link to it would help illustrate your problem.

Beginning a workout using a saved route and not following it from the start point will cause a problem. Routes are used to organize and compare identically performed workouts only.

-David

Current setup: e61 unbranded product code 0529654 Euro-B1 Silver. Firmware: 3.0633.09.04. Theme: Ovi blue. Service provider: 3 Sweden. Peripherals: Bluemax ext BT GPS module

Submitted by miikahuttu on 16-04-2009 10:02.

I haven't re-test with latest version.

When stating a route from end of that route, Sportstracker adds route-lenght instantly to distance.

I know that routes should follow very closely, but in case of exception invalid data is not acceptable.

Submitted by mirmer on 16-04-2009 10:24.

Hi David,

this is the workout. It shows the data from the route and a line from route start to the point of workout start.
https://sportstracker.nokia.com/nts/workoutdetail/index.do?id=866795
The main reason for stopping and restarting the workout was, that I was not able to assign the route to the workout while workout was started. I was a little bit lost in the forrest and wanted to know which way I havt to use. I havn't configured the route to this workout befor starting it.

I think NST should only show and save the real tracked data. Maybe it would be also nice if I can put two or more workouts togehter as one.

Thanks
Mike